Skip to main content

Funds released to repair Skagit Rover Bridge in Washington State

Some US$15.6 million in federal emergency funds is being made available to Washington State to help repair the Interstate 5 bridge over the Skagit River, which collapsed on May 23rd 2013. The funds were released by US Transportation Secretary Ray LaHood. A section of the four-lane bridge, located around 100km north of Seattle, collapsed into the water, disrupting travel in both directions. This funding follows $1 million in quick release emergency relief provided the day after the collapse. The Washington
June 19, 2013 Read time: 2 mins
Some US$15.6 million in federal emergency funds is being made available to Washington State to help repair the Interstate 5 bridge over the Skagit River, which collapsed on May 23rd 2013. The funds were released by US Transportation Secretary Ray LaHood.  A section of the four-lane bridge, located around 100km north of Seattle, collapsed into the water, disrupting travel in both directions. This funding follows $1 million in quick release emergency relief provided the day after the collapse. The 914 Washington State Department of Transportation (WSDOT) will use the funds to build a new replacement span. In the interim, WSDOT continues to operate detours and is building a temporary bridge. When the new replacement span is complete, WSDOT will remove the temporary bridge and install the new span. The bridge carries around 71,000 vehicles/day and is a major commercial route between Washington and neighbouring Canada. Approximately 11% of the vehicles are trucks transporting goods between the two countries. A full report into the bridge collapse has yet to be completed but questions remain as to whether the incident was caused by an over-height vehicle that struck a key structural member, causing sufficient damage for the section of the bridge to give way. The bridge also faces questions over the bridge’s long term future. This type of structure is no longer considered suitable for the traffic volumes and types of vehicles it is expected to carry.

For more information on companies in this article

Related Content

  • Weigh in motion and ANPR techology aid highway protection
    April 10, 2012
    Weigh-in-motion technology manufacturers have been involved in a number of significant highways tolling projects across the world in recent months, while others are looking to become involved in major new initiatives. Guy Woodford reports. The continuing global economic crisis did not prevent UK-based TDC Traffic Systems from recently securing the prized US$2.84million (€2.14million) contract to supply 20 high speed weigh-in-motion (WIM) systems for overweight pre-selection and enforcement in Saudi Arabia
  • Ground penetrating radar used to investigate tunnel deterioration
    May 13, 2015
    Using ground penetrating radar to determine reason for serious pavement settling in Kentucky-Tennessee tunnel Just a few years after the opening of the Cumberland Gap Tunnel, highway officials noticed moderate to severe settling of the continuously reinforced concrete pavement. The mountain tunnel provides an important link between Kentucky and Tennessee along US25E and the problem looked serious, with many voids discovered beneath the pavement surface. To investigate the problems, the Kentucky Transpor
  • Providence Viaduct project underway
    September 4, 2020
    Work is now underway on the Providence Viaduct project.
  • Crisis for German bridge condition
    April 18, 2025
    Germany’s bridges are in critical condition!