Colorado adopting new road surface standard

The Colorado Department of Transportation (CDOT) is implementing a new pavement texture standard. This revised specification is a response to feedback from the state's drivers with requirements for finishing Portland cement concrete pavement (PCCP). The main change is that the state is discontinuing the use of tining on all PCCP projects. In certain instances the grooved pavement texture produced by longitudinal tining can cause drivers to experience uncomfortable lateral vehicle movement. This is called gr
June 27, 2013 Read time: 2 mins
Transtec carried out extensive tests to ensure that CDOT’s revised surface specification would ensure sufficient skid resistance and safety for road users
The 5406 Colorado Department of Transportation (CDOT) is implementing a new pavement texture standard. This revised specification is a response to feedback from the state's drivers with requirements for finishing Portland cement concrete pavement (PCCP). The main change is that the state is discontinuing the use of tining on all PCCP projects. In certain instances the grooved pavement texture produced by longitudinal tining can cause drivers to experience uncomfortable lateral vehicle movement. This is called groove wander and CDOT's pavement design programme manager Jay Goldbaum explained that the state fully-investigated the practicality of moving away from longitudinal tining to address this ride comfort issue. The specification update is a result of CDOT's long-term study of PCCP textures used within the state, including analysis of texture, friction, noise, and accident records. This study was carried out by specialty pavement engineering firm The 5943 Transtec Group. But the texturing methods now required by the specification should not have an adverse effect on the safety of CDOT's pavements. CDOT's updated PCCP specifications require contractors to finish their pavement by broom, burlap or turf drag, or diamond grinding. According to Dr Robert Rasmussen, PE, vice president and chief engineer of Transtec, "Drag and diamond ground textures can be simple to construct, and they are capable of producing smooth and quiet pavement surfaces."

In addition to meeting CDOT's standards for safety and ride comfort, "The new specification will be easier to monitor," said Goldbaum. The standards require pavement texture to be verified with CDOT's CP-77B volumetric method test.

For more information on companies in this article

Related Content

  • IRF conference tackles transport green targets
    July 4, 2012
    The IRF's 2nd conference on roads and the environment addressed key transport targets, Mike Woof reports Reducing the impact of the road transport sector as a whole was the focus of the IRF's 2nd Roads & Environment Conference. Opening the event, Jean Beauverd, chairman of the IRF in Geneva said, "Evidence of global warming is now unequivocal. Even if we were to stabilise the effects of CO2 emissions, the effects would continue for decades. Eco-friendly processes have not yet reached the full acceptance tha
    Read More
  • THIS is a Paving Project– The I-15 CORE
    December 20, 2012
    Provo, Utah – The scope of the I-15 Corridor Expansion Project (I-15 CORE) in the state of Utah is nearly unprecedented because of the size of the project and the short completion deadline. Twenty-four miles (38.6 km) of removal and replacement of Interstate 15 between Lehi and Spanish Fork, widening the number of traveling lanes by two, for up to six lanes in each direction in 35 months. The new 364 lane miles (586 km) of concrete roadway will be slipformed 12 or 12.5 inches (305 or 318 mm) thick for a tot
    Read More
  • Fuel saving innovations
    April 19, 2012
    Up to a third of fuel consumption in cars is is spent in overcoming friction. However, both fuel consumption and emissions can be reduced by the use of new technology. This news comes from a joint study by the VTT Technical Research Centre of Finland and the Argonne National Laboratory (ANL) in USA. Innovative new technology can reduce friction by anything from 10-80% in various components of a car according to the study. And it should be possible to reduce car fuel consumption and emissions by 18% withi
    Read More
  • Colorado river bridge relieves congestion
    February 7, 2012
    Built in the shadow of the Hoover Dam, a new bridge is set to takes its place as another major tourist attraction. Patrick Smith reports
    Read More

Highlighted Content