Collapsed bridge section in Washington State being removed

Demolition equipment has been used to clear away wreckage from the collapsed section of the Skagit Bridge in Washington State. The bridge, carrying Interstate 5 over the Skagit River, collapsed last week and dropped a number of vehicles into the river. There were some injuries but not fatalities fortunately. The four lane highway bridge is located some 100km to the north of Seattle and is part of the highway linking with Canada. The full details of the collapse have yet to be revealed and will follow an inv
June 3, 2013 Read time: 1 min
Demolition equipment has been used to clear away wreckage from the collapsed section of the Skagit Bridge in Washington State. The bridge, carrying Interstate 5 over the Skagit River, collapsed last week and dropped a number of vehicles into the river. There were some injuries but not fatalities fortunately. The four lane highway bridge is located some 100km to the north of Seattle and is part of the highway linking with Canada. The full details of the collapse have yet to be revealed and will follow an investigation of the incident. The presence of a large truck on the bridge immediately before the collapse may however have been a factor. The bridge had been listed as not meeting current requirements.

Related Content

  • Innovative, flexible bridge formwork systems
    February 14, 2012
    Innovative formwork systems have been used to construct a variety of bridge structures. Patrick Smith reports. As part of the work on Germany's new A4 autobahn near Eisenach, the contracting joint venture awarded the formwork contract for two of the three viaducts to Doka. What makes this assignment so special to the company is that although the two steel composite bridges each have very different cross-sections, the JV is using the same overslung composite forming carriage to pour the carriageway slabs of
    Read More
  • Russian road repair
    January 14, 2015
    The driver of a construction truck in the Russian city of Voronezh recently had an unwelcome surprise when his own vehicle became the centre for a major road repair. The mixer truck was being driven along the road to a construction site when it suddenly fell into a large hole in the roadway. No ordinary pothole, this was sufficiently large for the rear of the vehicle to tumble inside, leaving only the cab poking out. The driver managed to jump out and was unhurt. The truck was less fortunate however as the
    Read More
  • $1.9 billion for Oregon-Washington bridge replacement
    May 20, 2025
    A further $1.9 billion is needed for the Oregon-Washington bridge replacement.
    Read More
  • Crash cushion design
    February 13, 2012
    There are key differences in crash cushion design and quality for the United States and European markets. Developments in barrier technologies have followed the varying demands of specific markets, resulting in manufacturers offering different solutions for US and European needs.
    Read More

Highlighted Content