Bang: big bridge blocking boulder broken by blasting

Following a recent earthquake in China, the roads and highways had to be cleared quickly to allow emergency deliveries, as well as general transport. One key bridge was blocked by a massive boulder that had been dislodged by the quake. As the boulder was too large to move using the excavators or bulldozers that the bridge could support, a decision was made to use blasting instead to clear the path. A drilling rig was brought into place and this machine bored a blasthole into the errant boulder, with the hol
April 24, 2013 Read time: 1 min
Following a recent earthquake in China, the roads and highways had to be cleared quickly to allow emergency deliveries, as well as general transport. One key bridge was blocked by a massive boulder that had been dislodged by the quake. As the boulder was too large to move using the excavators or bulldozers that the bridge could support, a decision was made to use blasting instead to clear the path. A drilling rig was brought into place and this machine bored a blasthole into the errant boulder, with the hole then being charged with conventional explosives. The blast then broke the boulder into pieces small enough for lighter machinery to move out of the way, allowing the bridge to be reopened to traffic.

Related Content

  • Construction machine market starting to recover
    March 19, 2012
    Sandvik’s Thomas Schulz talks to Claire Symes about market recovery in construction. In the three years since the last CONEXPO-CON/AGG exhibition, the construction industry has been through a tremendous change triggered by the global economic downturn. “At the time of the last exhibition in 2008, it was already clear that there was a levelling out occurring in the market,” said Sandvik president of construction Thomas Schulz. “But it was in October that year that the economy went into freefall after the col
    Read More
  • New Zealand’s Waterview project is moving closer to completion
    December 13, 2016
    New Zealand’s biggest road project is less than a year away from completion, and a lot of progress has been made since World Highways last looked at the project two years ago - Mary Searle Bell reports New Zealand’s Waterview project is moving closer to completion and will be the largest road project in the country. The NZ$2 billion Western Ring Route will see the creation of an alternative motorway to State Highway 1, which runs through the centre of Auckland. The 47km-long motorway will allow a large p
    Read More
  • Tennessee highway bridge explosive demolition VIDEO
    September 23, 2014
    Explosive demolition has been used to remove a Tennessee bridge that no longer met requirements. The bridge was on Tennessee Interstate 65 near Franklin in Williamson County and has been removed by a specialist contractor. The highway authorities decided to demolish the bridge following a crash involving a tanker truck in August of this year. The structure was pre-drilled with explosive charges and then demolished remotely, with the explosive demolition being carried out successfully and without any injurie
    Read More
  • Airport runway rebuild at Bologna
    May 15, 2019
    Rebuilding a runway requires special attention to detail to maximise efficiency and safety Airport runways face special challenges with regard to the loads they carry on a daily basis, particularly when aircraft are landing. A modern jet aircraft will typically land at speeds of around 240-260km/h, with a laden 747 weighing as much as 265tonnes at the end of a long flight. The stresses these large aircraft place on runway surfaces are enormous and not just with the massive impact forces exerted during
    Read More

Highlighted Content