Atlas Copco launches its new Hurricane B4-41/1000 CE booster compressor

Atlas Copco has launched its new Hurricane B4-41/1000 CE booster compressor, which it says offers advanced operational, safety and maintenance features that result in low downtime. “Drilling for oil, gas, water and geothermal energy are critical operations where there is little margin, or tolerance, for booster failure and downtime.
April 20, 2012 Read time: 1 min
RSS161 Atlas Copco has launched its new Hurricane B4-41/1000 CE booster compressor, which it says offers advanced operational, safety and maintenance features that result in low downtime.

“Drilling for oil, gas, water and geothermal energy are critical operations where there is little margin, or tolerance, for booster failure and downtime. Now Atlas Copco has introduced a CE-compliant booster compressor that is specially designed to provide maximum reliability in all conditions,” said the company.

The new Hurricane B4-41/1000 CE booster at INTERMAT has a capacity of 660litres/second (4m³/min) at a maximum discharge pressure of 69bar with a suction pressure of 24bar.
The 257 John Deere 4045 Power Tech diesel engine provides increased flows and pressures for improved borehole drilling.  

www.atlascopoc.com

Hall: 5B Stand: F027/015

RSS
View more stories
View more videos

For more information on companies in this article

Related Content

  • Ammann’s compaction technology delivers
    April 16, 2012
    ACE Pro – Ammann’s flagship system for monitoring and controlling compaction – is now available with GPS, allowing the operator to map the progress of compaction on-site. ACE Pro with GPS feeds absolute compaction data values back into the roller to automatically adjust amplitude and frequency to achieve the target compaction rate. It’s clever enough to stop compacting when the correct level is reached.
    Read More
  • BLS brings W series Tufpads to Europe
    January 6, 2017
    BLS Enterprises is promoting its full range of Tufpads polyurethane track pads for pavers and asphalt milling machines, including the European introduction of its W series. W series pads can be used as a direct replacement for Wirtgen’s EPS system. Polyurethane lasts two or three times longer than rubber, said president Barry Stoughton. The Tufpads system is available in both one-piece and two-piece versions. The one-piece pads are bonded to the metal, while pads in the two-piece system are bolted on. This
    Read More
  • BLS brings W series Tufpads to Europe
    April 19, 2012
    BLS Enterprises is promoting its full range of Tufpads polyurethane track pads for pavers and asphalt milling machines, including the European introduction of its W series. W series pads can be used as a direct replacement for Wirtgen’s EPS system. Polyurethane lasts two or three times longer than rubber, said president Barry Stoughton. The Tufpads system is available in both one-piece and two-piece versions. The one-piece pads are bonded to the metal, while pads in the two-piece system are bolted on. This
    Read More
  • JCB adds to Stage IIIB wheeled loader line
    January 6, 2017
    JCB has introduced two additional Stage IIIB-powered wheeled loaders, the 427 and the 437. Replacing the 426 and 436, the loaders use a Cummins QSB engine, which meets the requirements of Stage IIIB without the need for a diesel particulate filter or selective catalytic reduction (SCR). A variable geometry turbocharger improves response, while an optional five-speed powershift transmission with intelligent clutch cut-off system helps to reduce fuel consumption.
    Read More

Highlighted Content