Atlas Copco for Brazil bridge demolition

Brazilian demolition specialist Comprex was chosen to demolish a bridge connecting districts in the city of Vitória in the state of Espirito Santo. For environmental reasons, debris was not permitted to fall into the waterway under the bridge, and special arrangements had to be made for the removal of the demolition waste. Comprex chose Atlas Copco hydraulic breakers and CombiCutters for the jobsite where three new bridges have been built over the old bridge, which was no longer able to support the increasi
July 2, 2013 Read time: 2 mins
Bridge demolition under way in the city of Vitória, Brazil
Brazilian demolition specialist Comprex was chosen to demolish a bridge connecting districts in the city of Vitória in the state of Espirito Santo.

For environmental reasons, debris was not permitted to fall into the waterway under the bridge, and special arrangements had to be made for the removal of the demolition waste.

Comprex chose 161 Atlas Copco hydraulic breakers and CombiCutters for the jobsite where three new bridges have been built over the old bridge, which was no longer able to support the increasing volume of traffic crossing between the city districts. The old bridge, comprising 1,300m3 of reinforced concrete, needed to be removed, and an Atlas Copco SB 452 hydraulic breaker was used to remove the light structures, such as the parapet and concrete surfacing.

Two Atlas Copco MB 1700 hydraulic breakers and two CC 1700 CombiCutters, mounted on 2394 Volvo EC 210 and Cat 416E carriers, were used for the heavier task of removing the concrete layer from the beams and finally the ten beams themselves.

Demolition debris was received in a special boat and transported to a recycling plant.

“The MB 1700 and SB 452 hydraulic breakers gave impressive performance on the very hard concrete,” said Ronaldo Zucchi, owner of Comprex.

For more information on companies in this article

Related Content

  • Tackling Florida highway congestion
    October 4, 2016
    Congestion is a major problem in certain areas of US state Florida. Large number of commuters and tourists means that central Florida’s Interstate 4 (I-4) highway suffers particularly from congestion. Its proximity to Disneyland means that the traffic often comes to a complete standstill.
    Read More
  • Air helps build bridge
    February 13, 2012
    Chinese contractor Shanghai Sheng Xin Construction Co is using an Atlas Copco XAS 67 compressor on a new road bridge project in Shanghai. The new bridge is at Dan Ba Road, one of the main arteries in this older part of the city.
    Read More
  • PPRS: the positive side of structural failures
    March 27, 2018
    You learn from your failures, not your successes. That was the overall message for delegates during the day-two morning session on the impact of engineering structural failures. These lessons are also too often “painful”, said Anne-Marie Leclerq, deputy minister for infrastructure within the ministry of transport for the Canadian province of Quebec. On September 30, 2006, a span of the six-lane Concorde Bridge in Laval, near Montreal, collapsed crushing to death five people and injuring six. Only recently
    Read More
  • Tunnels eliminate bottlenecks
    February 10, 2012
    Some of the bottlenecks on the multi-lane Mittlere Ring, Munich, Germany, one of the main arterial roads circling the city centre have been eliminated by the addition of new tunnels. The Luise-Kiesselbach Square, the last section of this road improvement effort, is an important traffic hub south-west of the city where motorways A96 from Lindau and A5 from Garmisch meet, causing long delays in daily rush-hour traffic, writes Patrick Smith.
    Read More

Highlighted Content