Atlas Copco for Brazil bridge demolition

Brazilian demolition specialist Comprex was chosen to demolish a bridge connecting districts in the city of Vitória in the state of Espirito Santo. For environmental reasons, debris was not permitted to fall into the waterway under the bridge, and special arrangements had to be made for the removal of the demolition waste. Comprex chose Atlas Copco hydraulic breakers and CombiCutters for the jobsite where three new bridges have been built over the old bridge, which was no longer able to support the increasi
July 2, 2013 Read time: 2 mins
Bridge demolition under way in the city of Vitória, Brazil
Brazilian demolition specialist Comprex was chosen to demolish a bridge connecting districts in the city of Vitória in the state of Espirito Santo.

For environmental reasons, debris was not permitted to fall into the waterway under the bridge, and special arrangements had to be made for the removal of the demolition waste.

Comprex chose 161 Atlas Copco hydraulic breakers and CombiCutters for the jobsite where three new bridges have been built over the old bridge, which was no longer able to support the increasing volume of traffic crossing between the city districts. The old bridge, comprising 1,300m3 of reinforced concrete, needed to be removed, and an Atlas Copco SB 452 hydraulic breaker was used to remove the light structures, such as the parapet and concrete surfacing.

Two Atlas Copco MB 1700 hydraulic breakers and two CC 1700 CombiCutters, mounted on 2394 Volvo EC 210 and Cat 416E carriers, were used for the heavier task of removing the concrete layer from the beams and finally the ten beams themselves.

Demolition debris was received in a special boat and transported to a recycling plant.

“The MB 1700 and SB 452 hydraulic breakers gave impressive performance on the very hard concrete,” said Ronaldo Zucchi, owner of Comprex.

For more information on companies in this article

Related Content

  • INTERMAT 2012 launch for Atlas Copco HB 4100 hydraulic breaker
    February 3, 2012
    Atlas Copco is launching the new HB 4100 hydraulic breaker, which is lighter than its predecessor but offers better performance and higher efficiency.
    Read More
  • Mullum Mullum Valley untouched by progress
    July 20, 2012
    Preserving the unspoiled Mullum Mullum Valley was the major consideration when deciding to build a traffic tunnel The answer to one of the major issues facing construction of the A$2.5 billion EastLink route in Australia was simple: construct a tunnel. While it was expensive, those involved realised they had little option but to go underground to protect the environmentally sensitive Mullum Mullum Valley, an untouched area of wood and bushland in Melbourne. EastLink, the 39km toll road project on the easter
    Read More
  • Colorado river bridge relieves congestion
    February 7, 2012
    Built in the shadow of the Hoover Dam, a new bridge is set to takes its place as another major tourist attraction. Patrick Smith reports
    Read More
  • Doka delivers cantilevering for super-slim piers at Lahntal Bridge
    October 21, 2016
    Doka’s formwork expertise is currently in demand during the construction of one of the busiest motorway viaducts in Germany. The 400m six-lane Lahntal Bridge in Limburg dates from the early 1960s. Every day about 100,000 vehicles cross the bridge that spans the valley of the River Lahn. But traffic loads have increased sharply, so a new bridge is being built sited just a few metres west of the old viaduct. The new Lahntal viaduct will measure a massive 43.5m in width, enabling eight lanes plus hard shoul
    Read More

Highlighted Content