Skip to main content

New alternative to batteries for EVs

A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batterie
November 15, 2013 Read time: 3 mins
A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batteries, these reduce battery life considerably. The charging time has been identified as a major reason for the slow adoption rate of EVs around the world. However a team of engineers is working on a novel solution by developing a graphene supercapacitor that can store almost as much charge as a lithium ion battery but charges in just 16 seconds.

This new capacitor is being developed at the Gwangju Institute of Science and Technology in South Korea. The team’s high-performance supercapacitors use graphene and are said to store almost as much energy as a lithium-ion battery. In terms of practicality, they can charge and discharge in seconds, and maintain 98% of their initial value after 10,000 cycles.

The project is using a highly porous form of graphene that has a very large internal surface area. This material is produced by reducing graphene oxide particles with hydrazine in water agitated with ultrasound. The graphene powder is then packed into a coin-shaped cell, a pressure of 300kg/cm2 for five hours and dried at 140°C. The resulting graphene electrode is highly porous, which allows the electrode to accommodate much more electrolyte. And this determines the amount of charge the supercapacitor can hold. The team has measured the performance of the supercapacitor and it is said to store energy at a density of more than 64Wh/kg at a current density of 5A/gramme. That is almost comparable with lithium-ion batteries, which have an energy density of between 100 and 200Wh/kg.

The engineers say they can fully charge the supercapacitor in just 16 seconds and have repeated this some 10,000 times without a significant reduction in capacitance. This is significant as it also offers a practical alternative to the more limited working life of a lithium ion battery. The cost of the supercapacitor technology has not yet been revealed however.

Related Content

  • Utility machines with cutting edge design and efficiency
    May 29, 2013
    Utility machines with standout efficiency and cutting-edge cab design have come onto the market during the first few months of 2013. Guy Woodford looks at some of them. Case Construction Equipment and New Holland Construction have brought out what they claim are the market’s first Tier 4 Final emissions standard midi-excavators. The CX75C SR and CX80C models from Case are said to offer more performance power and greater operator cabin comfort than previous models. Tier 4 Final standards are said to have bee
  • Cummins offering electric powertrain for off-highway
    April 10, 2018
    Cummins is developing an all-electric powertrain for use in off-highway applications. This move follows the firm’s acquisition of the electric drive specialist Brammo. The system is designed to suit applications such as urban or underground duties, where it is necessary to minimise engine emissions. The package combines battery power with a compact diesel engine, linked directly to a generator. This offers a range-extended vehicle driveline (REEV). The prototype being unveiled utilises a 4litre F3.8 diesel
  • Wacker’s strong financial performance in 2017 showed growth
    March 23, 2018
    “Over the coming years, we want to rank among the top three providers of core products based on market share in the industry. We also aim to grow faster than the market. In the past year, we have proven that this is possible,” said Lehner. Within the framework of the “Strategy 2022” roadmap, the Group has set itself the goal of significantly exceeding the €2 billion revenue mark in the medium term and achieving an EBIT margin of over 11%. It aims to gradually reduce net working capital to below 30% of
  • The Road Ahead
    August 5, 2020
    According to recent figures, there are over 560,000 potholes that pose a risk of damage to vehicles in the UK alone, and the situation is similar in countries across the globe.