Skip to main content

New alternative to batteries for EVs

A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batterie
November 15, 2013 Read time: 3 mins
A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batteries, these reduce battery life considerably. The charging time has been identified as a major reason for the slow adoption rate of EVs around the world. However a team of engineers is working on a novel solution by developing a graphene supercapacitor that can store almost as much charge as a lithium ion battery but charges in just 16 seconds.

This new capacitor is being developed at the Gwangju Institute of Science and Technology in South Korea. The team’s high-performance supercapacitors use graphene and are said to store almost as much energy as a lithium-ion battery. In terms of practicality, they can charge and discharge in seconds, and maintain 98% of their initial value after 10,000 cycles.

The project is using a highly porous form of graphene that has a very large internal surface area. This material is produced by reducing graphene oxide particles with hydrazine in water agitated with ultrasound. The graphene powder is then packed into a coin-shaped cell, a pressure of 300kg/cm2 for five hours and dried at 140°C. The resulting graphene electrode is highly porous, which allows the electrode to accommodate much more electrolyte. And this determines the amount of charge the supercapacitor can hold. The team has measured the performance of the supercapacitor and it is said to store energy at a density of more than 64Wh/kg at a current density of 5A/gramme. That is almost comparable with lithium-ion batteries, which have an energy density of between 100 and 200Wh/kg.

The engineers say they can fully charge the supercapacitor in just 16 seconds and have repeated this some 10,000 times without a significant reduction in capacitance. This is significant as it also offers a practical alternative to the more limited working life of a lithium ion battery. The cost of the supercapacitor technology has not yet been revealed however.

Related Content

  • GM and Honda have a joint fuel cell programme
    July 4, 2013
    Car manufacturers General Motors and Honda are now working jointly on developing fuel cell powered vehicles. The two companies have established a long term partnership that will encompass bot the fuel cell system as well as storage solutions for the hydrogen fuel and also refuelling infrastructure.
  • Efficient site lighting from Atlas Copco
    August 24, 2016
    Atlas Copco now offers seven models in its mobile HiLight tower range. The HiLight range comprises of the H5+, B5+, V5+ and E3+ LED light towers, plus the V4, H4 and E2 metal halide variants. Four of the models benefit from efficient LED solutions. Atlas Copco’s latest LED light towers feature a novel, fully directional optic lens that maximises practical light coverage while minimising dark spots. A top-of-the-range LED light tower can illuminate an area of up to 5,000m2 with an average brightness of 2
  • Dutch job for Dynapac e-paver
    November 3, 2023
    Dynapac says its runtime – up to four hours on a single charge – is made possible by a lithium-ion battery and a powerful 55kW 3-phase permanent magnet synchronous motor.
  • The case for recycled asphalt
    October 24, 2017
    Debate continues over the use increased recycled asphalt for road surfaces - David Smith, development director at UK contractor FM Conway urges more cross-sector work to prove the case for a higher recycled asphalt content