Skip to main content

New alternative to batteries for EVs

A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batterie
November 15, 2013 Read time: 3 mins
A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batteries, these reduce battery life considerably. The charging time has been identified as a major reason for the slow adoption rate of EVs around the world. However a team of engineers is working on a novel solution by developing a graphene supercapacitor that can store almost as much charge as a lithium ion battery but charges in just 16 seconds.

This new capacitor is being developed at the Gwangju Institute of Science and Technology in South Korea. The team’s high-performance supercapacitors use graphene and are said to store almost as much energy as a lithium-ion battery. In terms of practicality, they can charge and discharge in seconds, and maintain 98% of their initial value after 10,000 cycles.

The project is using a highly porous form of graphene that has a very large internal surface area. This material is produced by reducing graphene oxide particles with hydrazine in water agitated with ultrasound. The graphene powder is then packed into a coin-shaped cell, a pressure of 300kg/cm2 for five hours and dried at 140°C. The resulting graphene electrode is highly porous, which allows the electrode to accommodate much more electrolyte. And this determines the amount of charge the supercapacitor can hold. The team has measured the performance of the supercapacitor and it is said to store energy at a density of more than 64Wh/kg at a current density of 5A/gramme. That is almost comparable with lithium-ion batteries, which have an energy density of between 100 and 200Wh/kg.

The engineers say they can fully charge the supercapacitor in just 16 seconds and have repeated this some 10,000 times without a significant reduction in capacitance. This is significant as it also offers a practical alternative to the more limited working life of a lithium ion battery. The cost of the supercapacitor technology has not yet been revealed however.

Related Content

  • Bergerat Monnoyeur showcases battery-powered prototype trio
    April 22, 2024
    The Cat 906 battery electric prototype compact wheel loader uses the well-accepted Next Generation 906 diesel variant platform.
  • Crash cushion design
    February 13, 2012
    There are key differences in crash cushion design and quality for the United States and European markets. Developments in barrier technologies have followed the varying demands of specific markets, resulting in manufacturers offering different solutions for US and European needs.
  • CEMCO meets tough VSI crushing challenge
    September 25, 2013
    Quarry firm Blue Mountain Minerals is improving output quality and productivity following the installation of a new CEMCO crusher. The facility is located in the Sierra Nevada foothills in Northern California, around two hours’ drive to the south east of Sacramento. This quarry has been providing customers in California with a variety of limestone and dolomite products for more than 150 years. Blue Mountain is the largest producer of limestone products in northern California and provides quality materia
  • Nissan develops next-gen fuel cell stack
    April 26, 2012
    Nissan Motor Company has released its next generation fuel cell stack (2011 Model) for fuel cell electric vehicles (FCEV). The latest technology development is part of the company's continuing efforts towards the realisation of a zero emission society. Through improvements to the MEA (membrane electrode assembly) and the separator flow path, which make up the structure of fuel cells, Nissan says it has significantly improved the power density of its fuel cell stack to 2.5 times greater than its 2005 model a