Skip to main content

Swedish motorcycle test

In Sweden crash testing has been carried out using motorcycles for the first time. Four crash tests were carried out at the VTI crash laboratory in Linköping, Sweden, for the client, the insurance company Folksam. As a result, Swedish motorcyclists can expect safer barriers according to VTI, the Swedish National Road and Transport Research Insitute. The VTI have participated in two different projects with focus on better safety for motorcyclists. The first project was run in cooperation with the Swedish Mo
November 10, 2015 Read time: 2 mins
In Sweden crash testing has been carried out using motorcycles for the first time. Four crash tests were carried out at the 7264 VTI crash laboratory in Linköping, Sweden, for the client, the insurance company Folksam. As a result, Swedish motorcyclists can expect safer barriers according to VTI, the Swedish National Road and Transport Research Insitute.

The VTI have participated in two different projects with focus on better safety for motorcyclists. The first project was run in cooperation with the Swedish Motorcyclists Association (SMC) and the Swedish parapet and barrier association (SVBRF). This studied existing literature to describe state-of-the art in motorcycle to barrier crash interaction. In the second project, initiated by Folksam, four full-scale crash tests on barriers with different kinds of protection was executed.

The joint result from these two projects opened a possibility to run a final crash test with a simple prototype of a plastic cover to shield the sharp edge on the top of the barrier. According to VTI, this prototype will help reduce injuries to motorcyclists in the event of an impact. In the various tests, different kinds of motorcycle protection systems were installed on a traditional W-beam and sigma post barriers.

The cover will let the motorcyclist slide along the barrier instead of getting stuck, lowering the severity of injuries.

The positive outcome is all about covering sharp edges and protruding parts, including the posts of the barrier. The plastic tube is a cheap and simple way of demonstrating a principle but it is yet not a finished product according to VTI.
The VTI crash laboratory is an accredited test facility for the EN1317 European test procedure for barriers. Being part of the international work with the procedure research engineer at the VTI crash laboratory, Jan Wenäll, will bring this experience to the ongoing development of an additional procedure for motorcyclists addition to the same procedure.

For more information on companies in this article

Related Content

  • Albedo: reflections upon performance
    May 16, 2020
    Albedo can impact pavement performance by a factor of between 10-15%.
  • Testing high performance road markings
    February 9, 2012
    High performance markings are among the safety products used to guide traffic safely, but they must be tested and checked. Patrick Smith reports. Road construction zones, zebra crossings, tunnels and areas with frequent fog are particular focal points with regard to road user safety. This is why manufacturers, authorities and contractors are always eager to use innovative road markings and special studs or, where necessary, lane control devices to assist both drivers and pedestrians in all conditions, parti
  • Young Driver Risk
    April 16, 2018
    Police in the US state of Ohio recently found themselves in a high-speed pursuit involving a vehicle taken without its owner’s consent. The chase lasted for around one hour and the vehicle hit speeds of up to 160km/h during the pursuit, which covered a distance of around 72km in all between Cleveland and Milan. Officers managed to box the car in and bring it to a halt, without anyone being injured. The driver was a 10-year-old boy who took his mother’s car, the second time that the lad had done this in just
  • Researching vehicle tyre safety
    February 15, 2012
    For the last two years a team of European partners has been examining the interaction between vehicle tyres and road surfaces. According to the UK's TRL, one of the partners in the European project Tyrosafe (Tyre and Road Surface Optimisation for Skid resistance And Further Effects), devices to measure skid resistance were developed at the forerunner of the UK's TRL in the 1930s.