Tilting Sensed

Tilting sensed Rugged inclinometers and tilt sensors are offered by Axiomatic, which has a series of new low cost units that can measure ±90º degrees or 360 degrees angular rotation. The angles are measured by a two-axis MEMS sensor, which senses acceleration caused by gravity. In a tilt sensor application, an out-of-range state can be transmitted as one of its outputs. The latest AX06025X series features CANopen networking, an RS-232 port or three Voltage outputs for communicating the angular measurement.
February 6, 2012 Read time: 2 mins
Axiomatic says that its rugged tilt sensors suit duties on earthmoving machines such as elevators
Tilting sensed Rugged inclinometers and tilt sensors are offered by 1532 Axiomatic, which has a series of new low cost units that can measure ±90º degrees or 360 degrees angular rotation. The angles are measured by a two-axis MEMS sensor, which senses acceleration caused by gravity. In a tilt sensor application, an out-of-range state can be transmitted as one of its outputs.

The latest AX06025X series features CANopen networking, an RS-232 port or three Voltage outputs for communicating the angular measurement. The inclinometer series also supports the SAE J1939 CAN interface under the p/n's AX0602XX. The J1939 inclinometer is fully configurable using the Axiomatic Electronic Assistant programming tool for PCs. All units are packaged for an IP67 rating with M12x2 5-pin connectors or M12 x1 5-pin. The inclinometer is designed to measure inclination angle in two orthogonal sensing directions X and Y in the range of up to ±90º. If vertically installed, it can measure an inclination angle in one sensing direction in the ±180º (0-360º) range.

For more information on companies in this article

Related Content

  • Stabilising the road
    February 7, 2012
    Terex's RS446C reclaimer/stabiliser is said to offer significant efficiency savings over its nearest rivals in the 373kW power class while offering similar working output. The machine is said to save up to 30% on fuel costs. The maximum cutting depth on the new model is now 508mm, an increase of 25% from the firm's earlier model. The RS446C now features a two-stage engine drive and three-speed cutter transmission. The new drive maximises break-out forces and delivers a production rate of up to 47m/min, whil
    Read More
  • Asphalt compaction answer
    February 8, 2012
    A new generation of asphalt compaction technology is coming to market, reports Mike Woof. The market for rubber tyred compactors has grown in recent years, prompting manufacturers to develop a new generation of machines.
    Read More
  • New turning simulation programme from Savoy
    August 22, 2013
    Savoy Computing has released a new version of its turning simulation program Autotrack 11, which extends and updates its support for a wide variety of base platforms as well as introducing new features. The software now supports the latest AutoCAD 2014, AutoCAD Civil 3D 2014 and other AutoCAD 2014 verticals and also will run in Bentley programs such as InRoads, MX and Power Civil. Updates for Bentley include support for full 3-axis vehicle rock and roll on 3D surface terrains, vertical headroom clearance an
    Read More
  • Engine innovations will cut emissions and increase performance
    October 1, 2014
    A series of innovations in engine technology will cut emissions and deliver fuel savings for customers - Mike Woof writes The start of 2014 saw the commencement of the final phase of the current set of engine emissions requirements for Europe and North America. With the introduction of the first set of Tier 4 Final/ Stage IIV emissions regulations, new generation diesel engines used in construction will deliver cleaner operating performance than ever before. These highly efficient engines have been devel
    Read More

Highlighted Content