Skip to main content

Vejdirektoratet finishes €18.75 million LED update

The Danish Road Directorate, Vejdirektoratet, said lower operating costs of LED highway lights mean the return on investment could be only six years.
By David Arminas May 5, 2025 Read time: 2 mins
LED lights and reduced lighting levels is helping the Danish Road Directorate save money and energy (image courtesy Vejdirektoratet, the Danish Road Directorate)

The Danish Road Directorate, Vejdirektoratet, has completed its largest lighting project, replacement of 23,000 lamps on the national road network with modern LED lamps.

Vejdirektoratet also said it has removed lighting on motorway sections where it was deemed not essential. Overall, the project means that energy consumption for road lighting has been reduced by about 65%, according to Thomas Danielsen, Denmark’s transport minister.

Total investment is about €18.75 million. However, the lower operating costs mean that the investment is expected to be paid back in just under six years. At night, the light is automatically reduced to half the previous level in many places to save energy, where there is no need for much brighter light.

Last December, the directorate published an updated version of the Danish Road Lighting Handbook - one of the most used Danish standards to meet the Danish Road Lighting Guidelines and which is heavily adopted for state roads, municipalities and road infrastructure.

The updated handbook introduces three new terms and concepts concerning light pollution, good light and biodiversity. These are “environmental zones”, “G-index” and “mDER (Melanopic Daylight Efficacy Ratio)”.  

Last May 2024, the Danish Road Directorate published the report “The Impact of Lighting on Animals, Plants and Humans.” The report helped form the basis for the measures the directorate incorporated into the updated road lighting handbook.

For more information on companies in this article

Related Content

  • Asphalt and bitumen - testing for performance
    February 29, 2012
    The stresses placed on modern asphalt and bitumen means that specialist equipment is essential to make sure performance specifications are met. As road traffic increases at a rapid pace and road safety becomes a priority issue, asphalt is put under increasingly higher stresses. For example, road surfaces are subject to compression, flexural tensions and tangential stresses: internal friction, depending on the aggregates, and the cohesion, guaranteed by bitumen's composition, are the two main properties whic
  • Testing high performance road markings
    February 9, 2012
    High performance markings are among the safety products used to guide traffic safely, but they must be tested and checked. Patrick Smith reports. Road construction zones, zebra crossings, tunnels and areas with frequent fog are particular focal points with regard to road user safety. This is why manufacturers, authorities and contractors are always eager to use innovative road markings and special studs or, where necessary, lane control devices to assist both drivers and pedestrians in all conditions, parti
  • Stiffer road surfaces could save billions in fuel say US researchers
    January 6, 2017
    There are fears that President Barack Obama is overlooking the benefits of good highway design following his recent announcement that he plans to impose higher fuel efficiency standards for medium and heavy-duty trucks by 2016.
  • Stiffer road surfaces could save billions in fuel say US researchers
    February 27, 2014
    There are fears that President Barack Obama is overlooking the benefits of good highway design following his recent announcement that he plans to impose higher fuel efficiency standards for medium and heavy-duty trucks by 2016.